adhesive friction
英
美
[网络] 黏著摩擦
双语例句
- On adhesive friction coefficient with fractal geometry
粘着摩擦系数的分形几何研究 - This paper sets up a mathematical model for calculating thermal balance of plunger-cylinder wall friction pair in axial plunger pump, analyzes the cause of producing adhesive wear on the friction pair, and puts forward a way to solve the problem.
本文提出了轴向柱塞泵柱塞&缸孔摩擦副热平衡计算的数学模型，进而分析了这对摩擦副产生粘着磨损的原因，并提出了解决办法。 - In the process of emergent brake, relations among brake press, parameters of the entire vehicle and adhesive coefficient between tire and road surface influence the distribution of brake disc friction temperature field greatly.
在紧急制动过程中，制动压力、整车参数以及轮胎与路面间附着系数之间的关系对制动器摩擦温度场分布有重要的影响。 - Abrasive, adhesive and oxidative wears are the three main wear modes found in the wear test, furthermore different wear modes have different effects on the friction and wear behaviors of the coatings.
对磨实验过程中主要出现磨料磨损、粘着磨损和氧化磨损三种磨损方式，而且磨损方式不同，镀层的摩擦磨损性能表现也不尽相同。 - The main contents are as following: ( 1) Discusses the adsorption force consists of adhesive force, negative pore water pressure and side friction.
本文的主要内容：（1）论述了吸附力由粘着力、负孔隙水压力、侧摩阻力组成。 - Thermal shock cracking in friction surface, over heated and over burned microstructure in sub surface, adhesive element diffusion from surface to center occur due to friction heat. Layer delamination occurs also on the worn surface of the steel.
因摩擦热的影响，制动后钢的摩擦表面出现热震开裂，表层组织过热甚至过烧，表面的粘着物由表向里扩散； - It provides theoretical foundation for determining the size of pressing load. Finally, a fractal model of adhesive friction coefficient is proposed by comparing the normal elastic load with the normal plastic load acting on particle contact points.
最后，通过比较作用于颗粒接触点的法向弹塑性载荷，提出了粘着摩擦系数的分形模型。 - The adhesive forces and friction forces between antigen and antibody were investigated.
对抗原和抗体分子间相互作用的粘附力和摩擦力进行研究。 - The results showed that for the material without graphite, the main wear mechanism was adhesive, the friction coefficient(μ) and wear rate(△ W) were larger;
结果表明：不含石墨时，材料的摩擦系数和磨损率均较大，磨损主要为粘着磨损； - The results show that the plow effect between friction pairs and adhesive area of friction surface could be effectively reduced with incorporation of SiC particles, which decrease the mass-loss wear of composite plating layer.
结果表明：SiC颗粒的加入能有效地降低摩擦副之间的犁沟效应及摩擦表面发生粘着的面积，从而减少镀层的磨损。